
How to make a Sonic table cover
Covering a table or desk is an important part of any home, but sometimes the tables are covered with other things.
This cover is a great solution for adding some texture to your tabletop.
Here’s how to make your own.
1.
Find the right material.
Some tables have a flat surface to add some texture and a bump on the top that can be glued or hammered into place.
These can be a solid piece of wood or a decorative metal plate.
If you don’t have a table, you can use a piece of foam board or some plastic foam board to make it look like the table is made of foam.
For this cover, I used the vinyl of a table I had lying around.
The plastic foam is a little thicker than the wood, so you’ll want to use a lot of it. 2.
Get a ruler.
The best ruler to use is the one you buy from Home Depot.
You can use it to cut the foam out of the foam.
If the foam is really thick, it can take a little bit of time to cut out all the pieces.
3.
Cut out your pieces.
To make the table, cut the pieces out of wood and plastic foam.
You’ll have to cut each piece of the cover out of two pieces: one for the edges and one for each corner.
I used a piece for each side.
To create the corners, I put the pieces on the table at a 90-degree angle.
For the edges, I made them as round as possible, then glued them to the table.
I also glued the pieces to the foam by using a rubber band to hold them together.
I just pressed the pieces together and the rubber band was a bit too big for me. 4.
Cut the pieces apart.
For each corner piece, I took one of the edges out, and glued it onto the plastic foam, and the other piece onto the foam, with a screw driver.
This was a little difficult to do because the plastic felt a bit flimsy.
I tried to make the edges as even as possible with my ruler, but they weren’t quite right.
5.
Glue them together again.
Gluing the pieces was a good idea because they should be glued together so that the corners are in the same place.
Then I took the two pieces I had glued together and pressed them together in the center.
This created a smooth surface.
This finished cover will make a great table cover for your next gaming party!